Electronic Weeping System for Car Wash
The Dixmor DX1000 Weep Mizer is an automatic microprocessor system that controls your weep system. Reliably cycles weeping on and off only when needed to save water and money. Replaces old methods using cheap thermostats to open solenoid valves, which is not nearly as efficient.
Features:
- Eliminate “free” rinsing
- Cycles your weep system on and off for maximum dollar savings
- Continuous display of outside temperature for your convenience
- Automatic secondary function controlled by rise or fall of temperature
- Easy manual override of automatic operation for either output
- Use of multiple sensors possible; weep system controlled with coldest
- Battery backup to eliminate reprogramming in case of power failure
- Built in “FAIL SAFE” program for peace of mind operation
- Easily programmable with two push buttons
- Maintains memory of time temperature was below turn on point, time water actually ran, in hours, high and low temperature since last reset
Specifications:
- 120 volt AC power required
- 24 or 120 volt AC output voltage
- Output 1 Operation: Programmed for N.O. valve, N.C. optional
- Output 2 Operation: Standard on/off switching
- Accuracy Range: plus or minus 1/2 degree – 20 to 110
- Minimum 18 gauge for all 120 volt hookup wiring
- 3 AMP maximum fuse
- Long-life lithium batteries (installed)
WARNING: This product can expose you to chemicals including Lead, which is known to the State of Californiato cause cancer and birth defects or other reproductive harm (For more information go to www.p65warnings.ca.gov).
